Gen2 carrier center support bearing replacement
- Thread starter JayQQ97
- Start date
Before I had my shop, thats the way it was done in my garage.
Rock62
Well-Known Member
Yes, simple easy task.
Hardest part is not getting heavy handed on the U-joint reassembly. Knock those needle rollers out of position, then you can split a cap trashing the u-joint. At best you'll need to disassemble, put the rollers back in place and try again. None of this is a heavy force press fit.
Hardest part is not getting heavy handed on the U-joint reassembly. Knock those needle rollers out of position, then you can split a cap trashing the u-joint. At best you'll need to disassemble, put the rollers back in place and try again. None of this is a heavy force press fit.