Aftermarket inner fender liners

bojangles, what clips did you use to hold the units in place? Are the OE units reusable, and how do you remove them?

Thanks a lot for your help.

This makes life easy and gets used for other clips. U can use a screwdriver, tho it may break the clips.
https://www.amazon.com/dp/B0002SRCMO/ref=cm_sw_r_other_apa_i_EPfLCb90VZ7P5

As for securing, the oem clips seem weak imho.
I used bolts at first with washers and nylocks on the top portion and these on the bottom section (no weight).. i have since swapped to using these all around, they pop right in and are secure. Tested to 100mph "on a closed course".

I got two bags and have a few extra clips now.

https://www.amazon.com/dp/B00OK8EJO6/ref=cm_sw_r_other_apa_i_CNfLCb9SVXMEA

And youre welcome
 
Last edited:
Thank you again for the info, bojangles. One last question. I PROMISE it is the last question. How thick is the material? I assume 1/8 inch.

Thanks.
 
Thank you again for the info, bojangles. One last question. I PROMISE it is the last question. How thick is the material? I assume 1/8 inch.

Thanks.
Sorry the toolbox is a pita to get to for a tape measure right now, but how about the stock version next to the new splash guards/skirts?

The stock crap is so thin, it almost looks like this is a picture of a sheet of rubber delaminating or something. Its not, its a pic i took a long time ago of the comparison of the stock vs aftermarket gaurds/skirts.

The paper thin thing on top is stock
Click on pic for fullsize if u want

20170404_124441.jpg
 
Back
Top