Tools...

found a better deal on that tool
much better deal
from Japan AmaYama
pending for the approval...

amayama  tool preOrder 4-7-24.jpg
 
Is there a special service tool SST
For the proper safe removal of these?
O2 sensor  connector wings to properly remove harness side from transfer clamp.JPG
 
is this a good enough product to use on a Gen2 splash shield under the transmission area, the middle skid or splash shield

1714757419937.png
 
Idk, I used it after wire wheeling some rusty I-beam's at my shop. Turned them flat black making those beam's look primered. I then brushed them down with a good gray oil based paint. That was about 4 years ago. They still look the same, not looking rusty anymore.
 
Back
Top